Twin Dolphin Marina, A CRUISERS NET SPONSOR, sits perched on the southern shores of Manatee River, just short of the Highway 41 Business bridge. We get lots of praise for this fine marina and their commitment to facility upgrades, see FOCUS ON.
Our thanks to Sean Welsh for this excellent, detailed explanation of bridge clearance boards.
Bridge Clearances Explained by Sean Welsh USCG licensed Master inland, Mate near coastal I was asked by the moderation team to write a few words about bridge clearance markings, after the comments on a recent post revealed that there is a lot of confusion on the subject. That seemed straightforward, but, as it turns out, it’s messy. That probably accounts for some of the confusion, so let me see if I can shed some light.
There is a standard for these markings, which are officially known as “Vertical Clearance Gauges” on the ICW and other federal waterways, codified in federal law as 33 CFR § 118.160. Among other things, this standard requires black markings on a white background, “foot marks” (horizontal lines of a specific size), specific spacing of numbers, location at the right side of the channel, and regular maintenance.
This Vertical Clearance Gauge complies with the regulations. “Foot marks” every foot show the clearance; on this board the numerals are next to the foot marks every other foot. This board reads just a hair over 65′, as the entire foot mark and a little white below it is visible.
If all bridges were marked according to this standard this would be an easy post to write. But the reality is that state or county road maintenance departments, railroads, and other bridge owners, and not the federal government, are actually responsible for installing markings on bridges, and there appears to be little consequence for these entities when they break federal law by straying from the standard. The bridge that prompted this post, the infamous Wilkerson Bridge in North Carolina, is one of the many non-compliant bridges and thus the source of much confusion.
My own photo. This board, not compliant with standards. This board reads a couple of inches more than 64′. It’s hard to read because non-compliant colors have been used and the agency has failed to “… maintain each gauge in good repair and legible condition.”
Apart from the markings being a noncompliant white on a green background, the gauges on this bridge also lack foot marks (horizontal lines) of any kind, and have numbers every foot. Since the numerals are 12" tall, this means each number abuts the numbers above and below it. This is by no means the only bridge with this type of marking, but it gets the most discussion here because the bridge is lower than ICW standards and is on a non- tidal stretch of waterway, making it a tight fit for many sailboats.
On this type of clearance gauge, the clearance to low steel is between the largest number that is completely visible (not covered by any water at all) and the next larger number that is wholly or partially under water. This is a critical point to remember, because the human brain wants to see the largest number that is “mostly” visible, and count upwards from there. Among other things, this is because we are conditioned to see numbers increase from lower to higher elevations, and on a bridge gauge it’s the other way around.
This stands in contrast to many standards-compliant gauges, where the numerals are often (but not always) next to, rather than above, the foot marks. When you see a gauge where the foot marks fall mid-numeral, it is the bottom edge of the mark, and not the bottom edge of the numeral itself, that shows the level.
On the ICW, most compliant numerals will be either 12 or 18 inches tall and spaced every two feet. But on bridges sized for ships or large tows, which need to be visible from much further away, you will find gauges where numerals may be spaced five or ten feet apart and are much larger in size. Compliant gauges, whether on fixed or movable bridges, show the clearance to “low steel” which is the lowest hard part of the bridge that is directly over the navigation channel. The edges of the channel are defined by the red channel limit lights, which are often on the fenders but sometimes hang below the span. If you stray outside these markers you may have lower clearance. Also, the “range lights” which are the green mid-channel lights that hang below the span, are not considered “low steel” and thus may hang down lower than the clearance measurement. If your clearance is close, pass between the range and the channel limits and do not take the range down the middle.
Having said that, once again there are some agencies out there installing non-compliant gauges and I have seen some, notably on drawbridges, which show the clearance “at center” as noted on the sign. When in doubt, call the bridge tender and ask. They are generally not allowed to tell you the clearance, but they can usually state whether the gauge reads low steel or center-span, and in the case of low steel gauges, how much additional clearance may be available center span.
While I am on the subject, now is a good time to remind everyone that bridge clearances marked on charts show the low steel clearance at “mean high water” (MHW) for tidal bridges, and at “normal pool” for river bridges. Actual clearance may be less; spring tides can be well above MHW and there may be freshet on top of that, and river pools vary greatly.
Bridges, their clearances, and movable bridge regulations and schedules can be found in the relevant edition of the Coast Pilot. Every skipper should carry the local Coast Pilot edition on board, available as a free download. Temporary clearance changes, for example due to construction work, can be found in the current issue of the Local Notices to Mariners (LNMs), which, again, every skipper should download and check as part of their voyage planning.
The total number of Atlantic tropical cyclones that strengthened from weak Category 1 storms into major hurricanes within a 36-hour window has more than doubled in the last 50 years, a new analysis finds.
Kitty Hawk’s oceanfront is shown not long after high tide while Hurricane Sandy was passing North Carolina Oct. 29, 2012, from the center line of N.C. 12, which is covered by sand, water and debris. Photo: NCDOT
Harborwalk Marina, A CRUISERS NET SPONSORS, is only a boardwalk stroll away from Georgetown’s Historic District for history, entertainment, great food and shopping. Harborwalk Marina is the third marina on your starboard side as you enter the protected waters of Georgetown.
Happy Halloween! Are you ready for sticky fingers, melting chocolate everywhere, and sugar crashes? Don’t go out trick or treating without Kanberra Wipes®. Perfect for before and after cleaning up the kids and keeping any surface clean and safe.
Receive free Kanberra Wipe with purchase over $49.99. Must add wipes to cart for discount to apply. Offer valid until November 3rd, 2023.
We at NAVCEN are thrilled to announce significant advancements in our ability to deliver Broadcast Notice to Mariners (BNMs) across all US waterways. This achievement is the culmination of years of effort, and we’re proud to relay that every single one of the USCG’s 37 Sectors and 9 Districts are now actively transmitting BNMs. As part of our commitment to harnessing technology for safer navigation, we have augmented the required VHF radio delivery method to providing real-time information directly to registered devices. This ensures that mariners and the public can access real-time safety data wherever they are, at the touch of a button. For those involved in route planning, we’ve also introduced an archive on the NAVCEN website containing all BNM data, making it even easier to check the status of navigable waterways before setting sail. NAVCEN is dedicated to leveraging technology to bolster the safety and efficiency of our maritime community, and we invite you to explore these enhancements by visiting the Broadcast Notice to Mariners section on the Navigation Center website: Broadcast Notice to Mariners | Navigation Center (https://www.navcen.uscg.gov/).
America’s most-decorated battleship from World War II helped win the war in the Pacific. Now, the USS North Carolina is fighting for resiliency amid rising water levels.
Be the first to comment!